Witam,
Proszę o pomoc przy konfiguracji SPAN porta na Nexusie 7000. Interesuje mnie łapanie ruchu z trzech interfejsów gigowych w dwóch kierunkach i kierowanie na jeden interfejs wyjściowy. Wspomnę tylko, że łączne obciążenie 3 interfejsów (eth 1/1 - 3) nie przekracza 100Mbit/s up/down.
Moja konfiguracja:
-------------------------------------------------------
monitor session 1
description TEST
source interface Ethernet1/1 both
source interface Ethernet1/2 both
source interface Ethernet1/3 both
mode extended
no rate-limit
destination interface Ethernet1/20
no shut
interface Ethernet1/20
description TEST
switchport
switchport monitor
interface Ethernet1/1 - 3
description
switchport
switchport access vlan 10
spanning-tree port type edge
Nexus# show monitor session 1
session 1
---------------
description : TEST
type : local
mode : extended
ssn direction : both
state : up
source intf :
rx : Eth1/1 Eth1/2 Eth1/3
tx : Eth1/1 Eth1/2 Eth1/3
both : Eth1/1 Eth1/2 Eth1/3
source VLANs :
rx :
tx :
both :
source exception :
filter VLANs : filter not specified
destination ports : Eth1/20
Software
BIOS: version 3.22.0
kickstart: version 6.2(2)
system: version 6.2(2)
BIOS compile time: 02/20/10
kickstart image file is: bootflash:///n7000-s1-kickstart.6.2.2.bin
kickstart compile time: 7/9/2013 20:00:00 [08/22/2013 05:55:58]
system image file is: bootflash:///n7000-s1-dk9.6.2.2.bin
system compile time: 7/9/2013 20:00:00 [08/22/2013 08:36:55]
---------------------------------------------------------------------------------
Co działa:
- wpada na SPAN port ruch generowany z VLANa innego niż 10
Co nie działa:
- NIE wpada cały ruch generowany wewnątrz VLANu 10 (puszczam pinga z VLAN10 na serwery wpiete w porty eth 1/1 - 3 i na SPAN porcie nic się nie pojawia)
Dzięki za pomoc!