Mam dziwną sytuację, dwa switche:
1. WS-C2960X-24TS-LL (C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E3)
2. WS-C2960X-48TS-L (C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E4)
i moduły: GLC-SX-MMD
Po włożeniu do pierwszego switcha, moduł jest widoczny i działa:
Kod: Zaznacz cały
sh inventory
NAME: "1", DESCR: "WS-C2960X-24TS-LL"
PID: WS-C2960X-24TS-LL , VID: V03 , SN: FOC2011Z0J2
NAME: "GigabitEthernet0/26", DESCR: "1000BaseSX SFP"
PID: GLC-SX-MMD , VID: V01 , SN: FNS17100B2F
Kod: Zaznacz cały
sh inventory
NAME: "2", DESCR: "WS-C2960X-48TS-L"
PID: WS-C2960X-48TS-L , VID: V03 , SN: FCW1916A1Q9
Kod: Zaznacz cały
sh interfaces g2/0/52 capabilities
GigabitEthernet2/0/52
Model: WS-C2960X-48TS-L
Type: unknown
Speed: 1000
Duplex: full
Trunk encap. type: 802.1Q
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off,on,desired),tx-(none)
Fast Start: yes
QoS scheduling: rx-(not configurable on per port basis),
tx-(4q3t) (3t: Two configurable values and one fixed.)
CoS rewrite: yes
ToS rewrite: yes
UDLD: yes
Inline power: no
SPAN: source/destination
PortSecure: yes
Dot1x: yes
Czy coś tu przeoczyłem, wersję IOSa, hardware'u, licencji ???