Enter configuration commands, one per line. End with CNTL/Z.
xx(config)# interface Ethernet1/38
xx(config-if)# channel-group 21 mode active
command failed: port not compatible [auto-negotiate]
** You can use force option to override the port's parameters
** (e.g. "channel-group X force")
** Use "show port-channel compatibility-parameters" to get more information on failure
Jak rozumiem komunikat interface winien być tak samo skonfigurowany jak inne w portchannelu i tak jest.
(eth1/37 to int który jest w po21, eth1/38 to int, który próbuję dodać do po21)
Kod: Zaznacz cały
interface Ethernet1/37
switchport access vlan 102
channel-group 21 mode active
interface Ethernet1/39
switchport access vlan 102
Ethernet1/37
Model: N3K-C3172PQ-XL
Type (SFP capable): 10Gbase-(unknown)
Speed: 100,1000,10000
Duplex: full
Trunk encap. type: 802.1Q
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off/on),tx-(off/on)
Rate mode: dedicated
Port mode: Routed,Switched
QOS scheduling: rx-(8q2t),tx-(7q)
CoS rewrite: yes
ToS rewrite: yes
SPAN: yes
UDLD: yes
MDIX: no
TDR capable: no
Link Debounce: yes
Link Debounce Time: yes
FEX Fabric: yes
dot1Q-tunnel mode: yes
Pvlan Trunk capable: no
Port Group Members: none
EEE (efficient-eth): no
PFC capable: no
Buffer Boost capable: yes
Breakout capable: no
Ethernet1/38
Model: N3K-C3172PQ-XL
Type (SFP capable): 10Gbase-(unknown)
Speed: 100,1000,10000
Duplex: full
Trunk encap. type: 802.1Q
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off/on),tx-(off/on)
Rate mode: dedicated
Port mode: Routed,Switched
QOS scheduling: rx-(8q2t),tx-(7q)
CoS rewrite: yes
ToS rewrite: yes
SPAN: yes
UDLD: yes
MDIX: no
TDR capable: no
Link Debounce: yes
Link Debounce Time: yes
FEX Fabric: yes
dot1Q-tunnel mode: yes
Pvlan Trunk capable: no
Port Group Members: none
EEE (efficient-eth): no
PFC capable: no
Buffer Boost capable: yes
Breakout capable: no
EDIT: Do listingów konfiguracji, show, debug, etc używamy znaczników
Kod: Zaznacz cały
Ułatwia to czytanie wątku
Seba