Posiadam wkładki SFP JD494A-C (kupowane dawno do HP)
Czy ktoś próbował z powodzeniem, lub może zna patent jak takie wkładki wykorzystać z Cisco?
Ja kombinuje z:
WS-C2960-24TC-L 12.2(55)SE10 C2960-LANBASEK9-M
poniżej wklejka z tego co wyrzuca konsola:
Kod: Zaznacz cały
LPD_24(config-if)#do sh int status
Port Name Status Vlan Duplex Speed Type
Fa0/1 notconnect 100 auto auto 10/100BaseTX
.
.
.
Fa0/24 notconnect 66 auto auto 10/100BaseTX
Gi0/1 err-disabled 1 auto auto unknown
Kod: Zaznacz cały
LPD_24#term monit
00:48:33: %GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port Gi0/1 has bad crc
Kod: Zaznacz cały
LPD_24#sh int status err-disabled
Port Name Status Reason Err-disabled Vlans
Gi0/1 err-disabled gbic-invalid
Kod: Zaznacz cały
LPD_24#show interfaces g0/1
GigabitEthernet0/1 is down, line protocol is down (err-disabled)
Hardware is Gigabit Ethernet, address is 001b.0dd9.e219 (bia 001b.0dd9.e219)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Auto-duplex, Auto-speed, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out