Cześć,
mam zagwozdkę z ustawieniem STP na przełącznikach Cisco Nexus 9300 i HPE JG933A.
Na przełącznikach mam do wyboru:
[HP]stp mode ?
mstp Multiple spanning tree protocol mode
pvst Per-Vlan spanning tree mode
rstp Rapid spanning tree protocol mode
stp Spanning tree protocol mode
N9300(config)#spanning-tree mode ?
mst Multiple spanning tree mode
rapid-pvst Per-Vlan spanning tree mode
Czy ktoś miał już przygody w podobnych scenariuszach. Podpowie w którą stronę iść.
W dokumentacji znalazłem znalazłem informację:
PVST
In an STP- or RSTP-enabled LAN, all bridges share one spanning tree. Traffic from all VLANs is
forwarded along the spanning tree, and ports cannot be blocked on a per-VLAN basis to prune loops.
PVST allows every VLAN to have its own spanning tree, which increases utilization of links and
bandwidth. Because each VLAN runs STP or RSTP independently, a spanning tree only serves its
VLAN.
A PVST-enabled HPE device can communicate with a third-party device that is running Rapid PVST
or PVST. The PVST-enabled HPE device supports fast network convergence like RSTP when
connected to PVST-enabled HPE devices or third-party devices enabled with Rapid PVST.
A port's link type determines the type of BPDUs the port sends:
• An access port sends STP BPDUs.
• A trunk or hybrid port sends STP BPDUs in VLAN 1 and sends PVST BPDUs in other VLANs.
https://www.catelsys.eu/images/Catelsys ... -Guide.pdf
Czy dobrze rozumiem, że jak ustawię na Nexus rapid-pvst, a na HPE pvst to nie będzie problemu i wszystko będzie działać prawidłowo ?
Spanning tree Cisco Nexus i HPE
Re: Spanning tree Cisco Nexus i HPE
Na obydwu ustaw pvst. Z urządzeniami hp nie mialem nigdy specjalnie problemow z dzialaniem pvst z rpvst+
-
- fresh
- Posty: 3
- Rejestracja: 22 lis 2019, 19:41
Re: Spanning tree Cisco Nexus i HPE
Tak jak pisałem Nexus ma do wyboru mst lub rapid-pvst, a HPE mstp, pvst, rstp i stp.
Czyli proponujesz na Nexus rapid-pvst, a na HPE pvst?
Czyli proponujesz na Nexus rapid-pvst, a na HPE pvst?