Hej,
CUCM -> Sip Trunk do gateway'a-> Gateway -> E1
Chcę zrobić sip trunk z Cisco Call Managera do Gateway'a i dalej wyjście przez E1.
Na tym trunku będą tylko połączenia wychodzące.
Każdy kto będzie wychodził przez sip trunk będzie się prezentował tym samym numerem (np 222222222).
Prezentacja jest zrobiona w route_pattern.
Wygląda, że sip trunk działa, ponieważ na gateway'u przy próbie nawiązania połączenia pojawiają się komunikaty Sip'owe.
Jak powinny wyglądać dial-peer'y na Gateway'u?
Wszystko co trafi do gatewaya powinno iść przez port 2/0/1, do którego podłączona jest E1.
Pozdrawiam
aw
CUCM -> Sip Trunk do gateway'a-> Gateway -> E1
np tak przy zalozeniu ze wyjscie na miasto masz przez zero i odrzucasz to zero juz na CUCMie (predot w Route Pattern):
Mysle ze potrzebny tez jest incoming dial-peer dla SIP czyli najprosciej
Kod: Zaznacz cały
dial-peer voice 10 pots
description --PSTN NATIONAL CALLS--
destination-pattern [1-9]........
progress_ind setup enable 3
progress_ind alert enable 8
port 2/0/1:15
forward-digits all
dial-peer voice 20 pots
description --EMERGENCY CALLS--
destination-pattern 9[89].
progress_ind setup enable 3
progress_ind alert enable 8
port 2/0/1:15
forward-digits all
dial-peer voice 21 pots
description --EMERGENCY CALLS--
destination-pattern 112
progress_ind setup enable 3
progress_ind alert enable 8
port 2/0/1:15
forward-digits all
dial-peer voice 30 pots
description --INTERNATIONAL CALLS--
destination-pattern 00.T
progress_ind setup enable 3
progress_ind alert enable 8
port 2/0/1:15
forward-digits all
Kod: Zaznacz cały
dial-peer voice 100 voip
description TO_CUCM
session target ipv4:<IP_CUCM>
incoming called-number .
no vad
dtmf-relay rtp-nte
session protocol sipv2