Mam problem z access pointem 2602i, tryb autonomiczny. Chciałbym zmienić opcję 'tcp mss', jednak przy próbie wpisania komend mam podwójne podpowiedzi do tego samego parametru: fragment z konsoli łatwiej wyjaśni o co chodzi:
Kod: Zaznacz cały
ap(config)#dot11 ?
aaa Authentication, Authorization, and Accounting
activity-timeout Activity timeout for device classes
addba ADDBA processing options
adjacent-ap Adjacent AP list configuration
arp-cache Enable DOT11 ARP cache
association association
auto-immune auto-immune feature
autoconfig l2tpv3 auto config
band-select Configure band select parameters
dhcp dhcp packets to be broadcasted to its clients
dot11u AP dot11u venue details
guest Configure Web Auth
holdoff-time holdoff time for authentication failed clients
ids Intrusion Detection System
igmp Enable DOT11 IGMP related feature
lbs Location Based Services (LBS) configuration
location WISPr Attribute Location-ID
management auto ap managememt
mbssid IEEE 802.11 config commands
network-map Enable DOT11 Network Map
phone Enable dot11 VOIP phones support
priority-map Enable dot11 priority mapping
ssid Configure radio service set parameters
syslog Enable syslog
tcp TCP
tcp TCP
tunnel Configure dot11 tunnel profile
vlan-name Configured a VLAN name and ID
webauth Webauth
wpa WPA parameters
ap(config)#dot11 tcp ?
mss TCP initial maximum segment size
mss TCP initial maximum segment size
ap(config)#dot11 tcp mss ?
<1200-1800> MSS
<1200-1800> MSS
ap(config)#dot11 tcp mss 1230
% Ambiguous command: "dot11 tcp mss 1230"
Wynikiem jest brak możliwości wpisania komendy, bo jest niejednoznaczna. Próbowałem już chyba z 6 softów, między innymi te poniżej
ap3g2-k9w7-tar.153-3.JBB.tar
ap3g2-k9w7-tar.153-3.JBB5.tar
ap3g2-k9w7-tar.152-4.JB4.tar
Skutek zawsze ten sam.
Ktoś pomoże?
EDIT: Do listingów konfiguracji, show, debug, etc używamy znaczników
Kod: Zaznacz cały
:!:
Seba