C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

Wszystko co się wiąże z technologiami bezprzewodowymi
Wiadomość
Autor
nowy
wannabe
wannabe
Posty: 210
Rejestracja: 10 paź 2006, 20:26
Lokalizacja: Warszawa

C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

#1

#1 Post autor: nowy »

Hej,

Dziś podczas zabawy z moim backupowym routerkie odkryłem że backup Internetu po 3G nie działa.
Jest problem z radiem. Sieć T-MOBILE. Czy ktoś ma pomysł jak aktywować to radio? Nie dam głowy, że po drodze nie zmienił się konfig :).

Kod: Zaznacz cały

NC-R1#show cellular 0 all
Hardware Information
====================
Modem Firmware Version = 
Modem Firmware built = 
Hardware Version = 
International Mobile Subscriber Identity (IMSI) = 
International Mobile Equipment Identity (IMEI) = 
Integrated Circuit Card ID (ICCID) = 
Mobile Subscriber International Subscriber
IDentity Number (MSISDN) = 
Factory Serial Number (FSN) = 
Modem Status = Offline
Current Modem Temperature = 0 deg C, State = Normal
PRI SKU ID = 0, SKU Rev. = 0.0

Profile Information
====================
Profile password Encryption level: 7


  * - Default profile 

Configured default profile for active SIM 0 is profile 1.


Data Connection Information
===========================
Data Transmitted = 0 bytes, Received = 0 bytes
Profile 1, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 2, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 3, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 4, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 5, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 6, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 7, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 8, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 9, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 10, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 11, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 12, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 13, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 14, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 15, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown
Profile 16, Packet Session Status = INACTIVE
        Inactivity Reason = Unknown

Network Information
===================
Current Service Status = Normal, Service Error = None
Current Service = Circuit Switched
Current Roaming Status = Home
Network Selection Mode = Automatic
Country = , Network = 
Mobile Country Code (MCC) = 0
Mobile Network Code (MNC) = 0
Location Area Code (LAC) = 0
Routing Area Code (RAC) = 0
Cell ID = 0
Primary Scrambling Code = 0
PLMN Selection = Automatic
Registered PLMN =  , Abbreviated = 
Service Provider = 

Radio Information
=================
Radio power mode = OFF, Reason = Unknown
Current Band = None, Channel Number = 0
Current RSSI = -0 dBm
Band Selected = not selected due to invalid band mask

Modem Security Information
==========================
Active SIM = 0
SIM switchover attempts = 0
Card Holder Verification (CHV1) = Disabled
SIM Status = Unknown
SIM User Operation Required = None
Number of CHV1 Retries remaining = 0

GPS Information
==========================

GPS Info
-------------
GPS State: GPS disabled

SMS Information
===============
SMS Service is not available
Number of outgoing SMS pending = 0

Error Information
=================


Modem Crashdump Information
===========================
Modem crashdump logging: off

lbromirs
CCIE
CCIE
Posty: 4101
Rejestracja: 30 lis 2006, 08:44

Re: C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

#2

#2 Post autor: lbromirs »

Nie widać w ogóle karty SIM.

Być może działało (jak pokażesz konfigurację, możemy wróżyć z fusów), ale teraz radio
nie widzi karty.

nowy
wannabe
wannabe
Posty: 210
Rejestracja: 10 paź 2006, 20:26
Lokalizacja: Warszawa

Re: C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

#3

#3 Post autor: nowy »

Show diag pokazuje tylko tyle:

Kod: Zaznacz cały

        Slot Cellular 0:
                Manufacture id : 0x00001199
                Product id    : 0x000068A3
                Hardware Version = 
                Firmware Version = 
                Firmware built   = 
I config

Kod: Zaznacz cały

chat-script ERA "" "AT!SCACT=1,1" TIMEOUT 60 "OK"

interface Cellular0
 no ip address
 ip nat outside
 ip virtual-reassembly in
 encapsulation slip
 dialer in-band
 dialer pool-member 1
 dialer idle-timeout 0
 async mode interactive

interface Dialer1
 ip address negotiated
 ip nat outside
 ip virtual-reassembly in
 encapsulation slip
 dialer pool 1
 dialer idle-timeout 0
 dialer string ERA
 dialer persistent

dialer-list 1 protocol ip permit

line 3
 exec-timeout 0 0
 script dialer ERA
 modem InOut
 no exec

Awatar użytkownika
drake
CCIE
CCIE
Posty: 1593
Rejestracja: 06 maja 2005, 01:32
Lokalizacja: Dortmund, DE
Kontakt:

Re: C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

#4

#4 Post autor: drake »

Tak w ogole to modem jakby nie jest wykryty ;) Sprawdz czy masz min. wymagany IOS i tak jak Lukasz wskazal, co sie dzieje z karta SIM - czy jest aktywna u operatora, bo router/modem jej w ogole nie widzi. Moze byc ze przy okazji RMA ktos zapomnial wyjac karte SIM?? ;)

Pozdruffka!
Never stop exploring :)

https://iverion.de

nowy
wannabe
wannabe
Posty: 210
Rejestracja: 10 paź 2006, 20:26
Lokalizacja: Warszawa

Re: C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

#5

#5 Post autor: nowy »

Modem działał OK na tym sofcie kilka msc. temu, karta SIM sprawdzona na tel. aktywna i jest Internet.

Wersja softu: 15.3(3)M

Co ciekawe podczas bootowania na consoli mam taki log:

Cellular0: Only PPP encapsulation supported

lbromirs
CCIE
CCIE
Posty: 4101
Rejestracja: 30 lis 2006, 08:44

Re: C881GW+7-E-K9 - problem z radiem 3G - T-Mobile

#6

#6 Post autor: lbromirs »

nowy pisze:Modem działał OK na tym sofcie kilka msc. temu, karta SIM sprawdzona na tel. aktywna i jest Internet.

Wersja softu: 15.3(3)M

Co ciekawe podczas bootowania na consoli mam taki log:

Cellular0: Only PPP encapsulation supported
To zupełnie niezwiązane. Skoro karta działa i jest w routerze, masz problem z modemem lub samym routerem.

ODPOWIEDZ