Konfiguruje FCoE i natknąłem się na pewien problem a mianowicie interfejs vfc jest up ale VSAN jest w procesie initializing
Kod: Zaznacz cały
IEDP03-N5K-SW02# sh int vfc 154
vfc154 is trunking
Bound interface is port-channel154
Hardware is Ethernet
Port WWN is 20:9a:8c:60:4f:98:10:bf
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is TF
Port vsan is 411
Trunk vsans (admin allowed and active) (411)
Trunk vsans (up) ()
Trunk vsans (isolated) ()
Trunk vsans (initializing) (411)
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
last clearing of "show interface" counters Mon Feb 12 07:38:26 2001
Interface last changed at Mon Feb 12 07:38:35 2001
Kiedy sprawdzam interfejs vfc to widzę ze oczekuje na flogi, zastanawiam się czy problem nie jest po stronie serwera i z jakiegoś powodu nie wysyła mi FLOGI. Rozmawiałem z adminem i twierdza, ze po ich stronie wszystko jest ok.
Kod: Zaznacz cały
IEDP03-N5K-SW02# sh int vfc 154 trunk vsan 411
vfc154 is trunking
Vsan 411 is down (waiting for flogi)
Kod: Zaznacz cały
IEDP03-N5K-SW01# sh int vfc 154
vfc154 is trunking
Bound interface is port-channel154
Hardware is Ethernet
Port WWN is 20:99:8c:60:4f:86:9d:ff
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is TF
Port vsan is 410
Trunk vsans (admin allowed and active) (410)
Trunk vsans (up) (410)
Trunk vsans (isolated) ()
Trunk vsans (initializing) ()
1 minute input rate 64 bits/sec, 8 bytes/sec, 0 frames/sec
1 minute output rate 80 bits/sec, 10 bytes/sec, 0 frames/sec
825 frames input, 87932 bytes
0 discards, 0 errors
826 frames output, 111724 bytes
0 discards, 0 errors
last clearing of "show interface" counters Fri Feb 9 22:24:20 2001
Interface last changed at Fri Feb 9 22:29:50 2001
Config
Kod: Zaznacz cały
interface vfc154
bind interface port-channel154
switchport trunk allowed vsan 411
no shutdown
policy-map type network-qos JUMBO_MTU
class type network-qos class-fcoe
pause no-drop
mtu 2158
class type network-qos class-default
mtu 9216
system qos
service-policy type network-qos JUMBO_MTU
service-policy type queuing input fcoe-default-in-policy
service-policy type queuing output fcoe-default-out-policy
service-policy type qos input fcoe-default-in-policy
vsan database
vsan 411 interface vfc154
vlan 411
fcoe vsan 411
Mial ktoś podobny problem bo w sumie nie wiem co jeszcze mogę sprawdzić, config wygląda w por zadku i raczej niczego nie przegapiłem?
Pozdro,