peer-keepalive not operational, peer never alive

Problemy i dyskusje z zakresu rozwiązań i technologii Data Center
Wiadomość
Autor
Awatar użytkownika
PatrykW
wannabe
wannabe
Posty: 1742
Rejestracja: 31 paź 2008, 16:05
Lokalizacja: UI.PL / Ubiquiti Polska.pl
Kontakt:

peer-keepalive not operational, peer never alive

#1

#1 Post autor: PatrykW »

Czy koniecznie musze uzyc do tego SVI lub mgmt0 ?
Na Nexus 7k taka sama konfiguracja mi smiga...

W tym przypadku mowa o 5k

sw 1
vrf context PEER-KEEPALIVE
vpc domain 2
peer-switch
role priority 8192
system-priority 16384
peer-keepalive destination 192.0.2.2 source 192.0.2.1 vrf PEER-KEEPALIVE
peer-config-check-bypass
delay restore 240
ipv6 nd synchronize
ip arp synchronize
interface Ethernet1/27
description KEEPALIVE-LINK
no switchport
channel-group 27 mode active
interface port-channel27
description VPC-KEEPALIVE-LINK
no switchport
speed 10000
vrf member PEER-KEEPALIVE
ip address 192.0.2.1/30
Kawalek loga

2009 Jan 17 19:38:55.607 sw-acc-0-vs.r0-0 %ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: V
LANs 1 on Interface port-channel32 are being suspended. (Reason: peer-keepalive
not operational, peer never alive)
# show vpc brief
Legend:
(*) - local vPC is down, forwarding via vPC peer-link

vPC domain id : 2
Peer status : peer link is down
vPC keep-alive status : Suspended (Destination IP not reachable)
Configuration consistency status : failed
Per-vlan consistency status : success
Configuration inconsistency reason: Consistency Check Not Performed
Type-2 consistency status : failed
Type-2 inconsistency reason : QoSMgr type-1 configuration incompatible
vPC role : none established
Number of vPCs configured : 2
Peer Gateway : Disabled
Dual-active excluded VLANs : -
Graceful Consistency Check : Disabled (due to peer configuration)
Auto-recovery status : Enabled (timeout = 240 seconds)

vPC Peer-link status
---------------------------------------------------------------------
id Port Status Active vlans
-- ---- ------ --------------------------------------------------
1 Po32 up -

vPC status
----------------------------------------------------------------------------
id Port Status Consistency Reason Active vlans
------ ----------- ------ ----------- -------------------------- -----------
1 Po1 down Not Consistency Check Not -
Applicable Performed
2 Po2 down Not Consistency Check Not -
Applicable Performed
# show interface status | i 27
Eth1/27 KEEPALIVE-LINK unknown e routed full 10G SFP-H10GB-C
Po27 VPC-KEEPALIVE-LINK noOperMem routed auto 10G --
sw 2
vpc domain 2
peer-switch
role priority 16384
system-priority 16384
peer-keepalive destination 192.0.2.1 source 192.0.2.2 vrf PEER-KEEPALIVE
peer-config-check-bypass
delay restore 240
ipv6 nd synchronize
ip arp synchronize
interface Ethernet1/27
description KEEPALIVE-LINK
no switchport
channel-group 27 mode active
interface port-channel27
description VPC-KEEPALIVE-LINK
no switchport
speed 10000
vrf member PEER-KEEPALIVE
ip address 192.0.2.2/30
# show vpc brief
Legend:
(*) - local vPC is down, forwarding via vPC peer-link

vPC domain id : 2
Peer status : peer link is down
vPC keep-alive status : Suspended (Destination IP not reachable)
Configuration consistency status : failed
Per-vlan consistency status : success
Configuration inconsistency reason: Consistency Check Not Performed
Type-2 consistency status : failed
Type-2 inconsistency reason : QoSMgr type-1 configuration incompatible
vPC role : none established
Number of vPCs configured : 2
Peer Gateway : Disabled
Dual-active excluded VLANs : -
Graceful Consistency Check : Disabled (due to peer configuration)
Auto-recovery status : Enabled (timeout = 240 seconds)

vPC Peer-link status
---------------------------------------------------------------------
id Port Status Active vlans
-- ---- ------ --------------------------------------------------
1 Po32 up -

vPC status
----------------------------------------------------------------------------
id Port Status Consistency Reason Active vlans
------ ----------- ------ ----------- -------------------------- -----------
1 Po1 down Not Consistency Check Not -
Applicable Performed
2 Po2 down Not Consistency Check Not -
Applicable Performed
# show interface status | i 27
Eth1/27 KEEPALIVE-LINK unknown e routed full 10G SFP-H10GB-C
Po27 VPC-KEEPALIVE-LINK noOperMem routed auto 10G --
hmm ?
.ılı..ılı.

http://www.linkedin.com/in/pwojtachnio
Potrzebujesz projektu na studia z zakresu Cisco Packet Tracer & GNS ? Just give me call :)

Integrujemy i wspieramy IT :)
https://www.ui.pl | https://facebook.com/UIPolska

Jedyne rozwiązania Ubiquiti Networks w Polsce!
https://ubiquitipolska.pl | https://www.facebook.com/groups/Ubiquiti.Polska

martino76
CCIE
CCIE
Posty: 883
Rejestracja: 17 gru 2010, 15:23
Lokalizacja: Barczewo

#2

#2 Post autor: martino76 »

Witam,

Per link tylko mgmt lub SVI dokumentacja dla N7K wspomina o L3 interfejsie, więc trzymaj się tego co mówi dokumentacja i zrób to na mgmt lub SVI. A nawet jak by wspierał L3 to szkoda linku 10G na keepalive 😊

Pozdro,

Awatar użytkownika
PatrykW
wannabe
wannabe
Posty: 1742
Rejestracja: 31 paź 2008, 16:05
Lokalizacja: UI.PL / Ubiquiti Polska.pl
Kontakt:

#3

#3 Post autor: PatrykW »

martino76 pisze:Witam,

Per link tylko mgmt lub SVI dokumentacja dla N7K wspomina o L3 interfejsie, więc trzymaj się tego co mówi dokumentacja i zrób to na mgmt lub SVI. A nawet jak by wspierał L3 to szkoda linku 10G na keepalive 😊

Pozdro,
Hej,

Dzieki :)
.ılı..ılı.

http://www.linkedin.com/in/pwojtachnio
Potrzebujesz projektu na studia z zakresu Cisco Packet Tracer & GNS ? Just give me call :)

Integrujemy i wspieramy IT :)
https://www.ui.pl | https://facebook.com/UIPolska

Jedyne rozwiązania Ubiquiti Networks w Polsce!
https://ubiquitipolska.pl | https://www.facebook.com/groups/Ubiquiti.Polska

Awatar użytkownika
konradrz
CCIE
CCIE
Posty: 400
Rejestracja: 23 sty 2008, 14:21
Lokalizacja: Singapore, SG
Kontakt:

Re: peer-keepalive not operational, peer never alive

#4

#4 Post autor: konradrz »

Wojtachinho pisze:

Kod: Zaznacz cały

interface port-channel27
  description VPC-KEEPALIVE-LINK
  no switchport
  speed 10000
  vrf member PEER-KEEPALIVE
  ip address 192.0.2.1/30
Z ciekawości - czemu dałeś keepalive w port-channel (jednoportowy)?

Z drugiej mańki - tamten dokument jest z zeszłej ery; obecnie da się użyć L3 10g portu na keepalive (w Nexusach 56xx; w 55xx nie jestem pewien, a za leniwy jestem by sprawdzić :). Po prostu nie warto.
Preferowany keepalive (w kolejności):
1. mgmt0,
2. osobny link L2 i SVI,
3. port L3.
Natomiast, tylko w przypadku 1. (mgmt0) masz święty spokój z non-disruptive upgrades (ISSU).

Seba
CCIE/CCDE Site Admin
CCIE/CCDE Site Admin
Posty: 6223
Rejestracja: 15 lip 2004, 20:35
Lokalizacja: Warsaw, PL

#5

#5 Post autor: Seba »

Czytając ten wątek o wczesnej godzinie porannej, zastanawiam się po co to utrudnianie sobie i innym życia, zamiast po prostu wybrać opcję nr 1 z listy Konrada...
Dajcie jakieś konkretne przypadki, gdzie użycie Mgmt0 nie było chodzące
"Two things are infinite: the universe and human stupidity; and I'm not sure about the universe."
A. Einstein

Awatar użytkownika
PatrykW
wannabe
wannabe
Posty: 1742
Rejestracja: 31 paź 2008, 16:05
Lokalizacja: UI.PL / Ubiquiti Polska.pl
Kontakt:

#6

#6 Post autor: PatrykW »

Szczerze to nie wiem, zawsze sobie robie pod gorke...
vPC domain id : 2
Peer status : peer adjacency formed ok
vPC keep-alive status : peer is alive
Configuration consistency status : success
Per-vlan consistency status : success
Type-2 consistency status : success
vPC role : primary
Number of vPCs configured : 2
Peer Gateway : Enabled
Peer gateway excluded VLANs : -
Dual-active excluded VLANs : -
Graceful Consistency Check : Enabled
Auto-recovery status : Enabled (timeout = 240 seconds)
vPC domain id : 2
Peer status : peer adjacency formed ok
vPC keep-alive status : peer is alive
Configuration consistency status : success
Per-vlan consistency status : success
Type-2 consistency status : success
vPC role : secondary
Number of vPCs configured : 2
Peer Gateway : Enabled
Peer gateway excluded VLANs : -
Dual-active excluded VLANs : -
Graceful Consistency Check : Enabled
Auto-recovery status : Enabled (timeout = 240 seconds)
.ılı..ılı.

http://www.linkedin.com/in/pwojtachnio
Potrzebujesz projektu na studia z zakresu Cisco Packet Tracer & GNS ? Just give me call :)

Integrujemy i wspieramy IT :)
https://www.ui.pl | https://facebook.com/UIPolska

Jedyne rozwiązania Ubiquiti Networks w Polsce!
https://ubiquitipolska.pl | https://www.facebook.com/groups/Ubiquiti.Polska

ODPOWIEDZ