Próbowałem zainstalować dziś SFP GLC-T na N5K ale port nie podnosił się. Kabel na pewno jest sprawny po podłączeniu do N2K, link odrazy się podnosił. Próbowałem innych SFP tego samego modelu, i link ciągle pozostawał jako not connected.
Tak dla jasności zmieniłem port speed z 10G na 1G i dalej problem był ten sam. Zauważyłem ze transceiver pokazuje mi calibration is invalid
Kod: Zaznacz cały
IEDP02-N5K-SW01# sh int et1/31 transceiver calibrations
Ethernet1/31
transceiver is present
type is SFP-1000BASE-T
name is CISCO-AVAGO
part number is ABCU-5710RZ-CS4
revision is
serial number is AGM170325Q9
nominal bitrate is 1300 MBit/sec
Link length supported for copper is 100 m
cisco id is --
cisco extended id number is 4
SFP calibration is invalid
Pozdro,