Mam problem Labujemy sobie przed produkcją UCS'a i chcemy zabootować serwery z SAN,,
Generalnie
2 UCSmini( UCS-FI-M-6324 )
podlaczony do JEDNEGO MDS (DS-C9148S-K9) 4'rema linkami dwa z jednego FI dwa z Drugiego
na kazdym FI jest portchannel z tych dwóch linków
sprzet który maja widziec serwery jest w VSAN'ie 3
no i generalnie mimo ze wszystko wyglada na dobrze skonfigurowane otrzymujemy takie cos
Kod: Zaznacz cały
FI2-B(nxos)# show npv status
npiv is enabled
disruptive load balancing is disabled
External Interfaces:
====================
Interface: san-port-channel 2, State: Trunking
VSAN: 1, State: Up
VSAN: 2, State: Up
VSAN: 3, State: Up, FCID: 0x710700
Number of External Interfaces: 1
Server Interfaces:
==================
Interface: vfc751, VSAN: 4094, State: Down
Interface: vfc755, VSAN: 4094, State: Down
Number of Server Interfaces: 2
FI2-B(nxos)# sh int vfc751
vfc751 is down (Error Disabled - VLAN L2 down on Eth interface)
Bound interface is Vethernet8943
Port description is server 1/1, VHBA vHBA_B
Hardware is Ethernet
Port WWN is 22:ee:8c:60:4f:c4:e0:7f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 3
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
29 frames input, 3272 bytes
0 discards, 0 errors
27 frames output, 2868 bytes
0 discards, 0 errors
Interface last changed at Mon Dec 21 23:54:02 2015
(Error Disabled - VLAN L2 down on Eth interface) < wtf ;( ?
Interface: vfc755, VSAN: 4094, State: Down < wtf*2 ?
na MDS
Kod: Zaznacz cały
interface port-channel1
channel mode active
switchport mode F
switchport trunk allowed vsan 1-3
switchport rate-mode dedicated
interface port-channel2
channel mode active
switchport mode F
switchport trunk allowed vsan 1-3
switchport rate-mode dedicated
Kod: Zaznacz cały
interface san-port-channel 2
channel mode active
switchport mode NP
switchport trunk mode on